Again, be very cautious and keep checking for a proper fit. TypeTwoFun had to use the Dremel to widen the hole there, too. Our voltmeter didn’t fit in the cut out either, so Mr. Some of the switches don’t have very much overlap, and you can easily make your hole too big very quickly. Be very careful when enlarging the opening for the toggle switch. We looked high and low for a switch that we could use in the face plate without any modification, but we didn’t find anything. TypeTwoFun did was use a conical grinding bit on the drill so the toggle switch would fit in the plate. □ But he isn’t an electrician by any means, and he says the project is really quite simple. For our project, we used this 7.5v-20v Blue LCD Digital Voltmeter Volt Panel Meter from Amazon, a toggle switch from Radio Shack, a nylon switch plate, and approximately two feet each of 16ga black and red electrical wire. All you really need is an LCD voltmeter and a toggle or momentary switch. The Pop Up Portal has all kinds of takes on this project. So when our summer fun was over, we tackled our first post-trip project: a battery monitor. We also realized that the battery was located under the king bed side, and when popped up, the bunkend would make it difficult to access and check our power source. We weren’t sure about our usage, and we had forgotten to bring a good voltmeter to check the battery. While the battery never left us without power, there were several times where we were unsure just how much juice we had left. Our battery did a great job powering the Santa Fe–sometimes for five days at a time. While we enjoy being off the grid, we still need a power source for a few things like lights and water. In fact, many of the best places to camp don’t have a place to plug in. On our big road trip, we discovered that our favorite campgrounds didn’t have hookups.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |